Princess 282969, Инструкция по эксплуатации

Страница: 8 / 36

8
On the rear of the ice-cube maker you will find a drainage outlet with valve cap that can be used to empty
the appliance. Unscrew the valve cap and drain the reservoir (if necessary, use a suitable hose). Once it
has emptied close the valve by replacing the cap.
PRINCESS TIPS
- Do not place the Ice Cube Maker on its side or upside down. Especially watch out for this when
moving the appliance.
- Do not position the machine up against other appliances or a wall. The ventilation holes should never
be covered.
- Do not use the Ice Cube Maker outdoors.
- Never submerge the appliance in water or any other liquid, as this can cause electric shock.
- Keep an eye on the Ice Cube Maker when within the reach of children. Of course be careful yourself,
as well.
- Unplug the appliance if you will not be using it for an extended period.
- Do not put the machine near heat sources.
- In case of damage to the appliance or its cord, we advise you to not use the device, but to return it to
the store for repair. Damaged cords must be replaced by our service department.
- Keep in mind that using parts which are not recommended by the manufacturer can be dangerous.
- Only use this appliance for its intended purpose.
- The coolant in the Ice Cube Maker is chemical waste, therefore the machine must be disposed of
properly, in an environmentally friendly way. Inquire about proper disposal with your municipal refuse
department.
- Children should be supervised to ensure that they do not play with the appliance.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the colour mar-
kings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L
or coloured red.
The wire which is coloured GREEN/YELLOW must be connected to the terminal which is marked with
the letter E or
and is coloured GREEN or GREEN/YELLOW
If a 13Amp (BS1363) plug is used, a 13Amp (BS1362) fuse must be fitted, or if any other type of plug is
used, a 13Amp fuse must be fitted, either in the plug or adaptor, or on the Distribution Board.
WARNING: THIS APPLIANCE MUST BE EARTHED