- - - -
3
IMPORTANT:
To change from Minutes and Seconds
M:S
to Hours and Minutes
H:M
. Press and hold the SCAN/UP
Button. When the display reaches 59:59 it will automati-
cally change to 1:00 Hour and the LED will switch from
M:S to H:M. The program value for the
H:M
indicator is
from 1:00 hour to 17 hours: 59 minutes.
4. Press the timer button again. The current audio
alarm length will appear in the display. Note: It is
set in seconds.
5. Press the SCAN/UP or SCAN/DOWN Arrow to
adjust the length of the audio alarm.
6. To program another channel, press the desired
channel button.Repeat programming procedures in
steps 2 thru 5 above. See figure 5.
7. When finished progamming each desired channel,
momentarily press the
PRINCE CASTLE
logo to
end the Program Mode. This saves the program
changes you have made for all channels.
figure 8
figure 6
`
741-501revA
Printed in USA 3/06 © 2006
OPERATION
1. Press a channel button to activate a timing cycle.
(Both channels can be activated and running at the
same time.) The time channel number with the
least amount of time remaining will be displayed in
the CHANNEL display, its time remaining will
countdown in the TIME display, and the time value
M:S or H:M will be illuminated.
2. Press the desired channel button three times within
five seconds to cancel an active timing cycle and
start another timing cycle. Press four times to
deactivate the channel timer completely.
IMPORTANT: The channel timer button’s multi-
colored LED indicator shows the status of the timer.
The indicator has two colors: green and red. The
LED will be green during the countdown. It will be
red during the auto reset cycle.
3.
The timer will countdown from the programmed
value to 0:00. At 0:00, the display alternates
between “CLN” and “HAND”, indicating it is time to
clean hands, the timer channel indicator will flash
red, and the audio alarm will sound for its preset
time. To manually cancel the audio alarm, press
the timer channel button once.
4. There are two audio alarm levels, high and low. To
select the high level, press the Prince Castle Button
and the SCAN/UP Arrow at the same time. To select
the low level, press the Prince Castle Button and the
SCAN/Down Arrow at the same time.
CLEANING
1.
Do not allow grease to build up on the timer, wipe it
down daily with clean damp cloth.
IMPORTANT: Do not use abrasive or chemical cleaners on
your timer, this may cause damage to the overlay.
figure 3
figure 4
1
59:59
1
1:00
2
3:00
figure 5
.25
