Instruction Manual VARORMAT
8
5.Operating Instructions
For the instructions mentioned in the current section please see the below picture 2.
5.1. Activation Instructions
Picture 2: Steam Genarator “Vapormat”
Fill with clean water the feedwater vessel 25lts( No 41).
Turn on the water inlet valve(Ball valve ½, No 26) in order to permit the water
circulation in the machine.
Turn on the main switch (No 31) and press the button ON on the keyboard.
The water pump starts to feed water the boiler. The green light No 2 (PUMP ON) of the
control keyboard (No 54) should be on. After a while, the green light No 1 (STEAM ON)
on the control keyboard, should be on. The boiler starts heating the water in order to
supply steam in about 15-20 min. (In case you have a model carrying a 6KW the heating
element the requested time for steam preparation is 9-11 min). The manometer should
reach 3,5 bars. The machine is ready to work.
Press the iron’s buttons on the control keyboard. Press only one button if the
requested produced steam is for 1 steam iron, or both buttons if the requested
produced steam is for 2 steam irons.
Adjust the temperature of the iron, by the thermostat knob, according to the fabric
requirements.
Adjust the steam consumption by the adjustor knob No 37, according to the fabric
requirements. You can start ironing!
In case of purchasing the Vapormat/3-6, turn on the switch of AD/5 cell for supplying
steam to the third iron.
WARNING ! To avoid burning accidents ,follow carefully the instructions below:
Fill the condensate vessel C (sketched below) with water,at a level of 5 cm.approximately.
Screw tightly cap D.Unlock safety blocker A.Turn on slowly the outlet valve B in order to
remove any water condensates from the boiler. After finishing, turn off the outlet valve B
and lock again safety blocker A.
54
