Instruction Manual Octopus
7
phase, 1 neutral, 1 grounding). The power should be secured with a tripolar circuit breaker
(3
Χ
10
Α
).
For any device that is connected to a 3-phased current, make sure that the rotation of the
motor is done clockwise.
CAUTION!
For your own safety, pay attention to all the warning labels (yellow colored) that
are placed on the machine. The manufacturer bears no liability for any damages or accidents
due to faulty supplying network or to not specified personnel.
5.
Operating instructions
For the instructions mentioned in the current section please see the
below
images (picture 4 & picture 5)
.
5.1
Activation Instructions
•
Turn on the main switch
No 1
•
Turn on the switch
No 2
to activate the suction.
•
Turn on the switch
No 3
to activate the heating on the ironing
surface.
•
Switch the thermostat that is placed below the buck to temperature
110°C
during the winter
and to 90°C during the summer.
•
Turn on the switch
No 4
to activate the heating
of the ironing bucks.
•
Whenever you want to activate the suction, step lightly on the foot pedal.
•
Adjust the intensity of the suction through the lever
No 5
, which
is located on the chimney. Adjust it from 0% - 100% depending
on the fabric (weight, quality etc.).
•
Adjust the amount of steam from the steam generator in
proportion to the intensity of the suction to avoid the
liquidification of the steam on the ironing surface. Thinner
fabric requires smaller amounts of steam, while thicker fabric
requires larger amounts.
5.2 Additional Instructions
*
In case your table disposes a blowing system of air (optional):
•
Adjust the pressure of the blowing depending on the fabric
(weight, quality etc.) from the lever
No 6
located beneath the
ironing surface.
•
To activate the blowing, step lightly on the foot pedal.
**In case the table disposes a Vario iron system (optional):
•
Hook the steam iron from the balancer and adjust the distance of the steam iron from
the working surface (approximately 5cm). After you have finished ironing, unhook the
steam iron from the balancer and put it on the iron rest mat.
5
Picture 4:
Switches
8
6
