l
Turn to 9 for Alaska Time Zone
l
Turn to A for Hawaii Time zone
l
Turn to 0 for Greenwich Mean Time (GMT)
2. Set transmitter display time mode:
set dip switch #8 to 12H or 24H
l
Flip switch to the UP position to select 24 hour time
l
Flip switch to the DOWN position to select 12 hour time
3. Set the transmitter standard time/britishsavingtime (ST/BST) preference.
set dip switch #7 to either ST/BST
l
Dip switch #7
(ST/BST) to the UP position. This will disable the British Summer Time (BST) correction on the
satellite transmitter. Where applicable, BST changes will be handled by the Receiver Switch.
For additional
information, see "Install Receiver Switch" located on page 12.
4. Carefully screw the Satellite Transmitter antenna onto the unit. Turn the antenna clockwise being careful to avoid cross threading
the antenna. The base of the antenna must be snug against the case.
5. Plug the supplied power supply into the transmitter.
6. Plug the power supply into a 220-240 VAC outlet.
Figure 4: Transmitter Rear View
Setup Receiver Switch
To access the Receiver Switch menu preferences, press the
Menu
button located on the front of the unit. By pressing and holding the
Menu button the Receiver Switch will cycle through the menu options.
l
While in the Channel menu option, if there are no changes made in a minute of entering a menu section, it will time out
and save the displayed value, exiting the menu mode.
l
If a value is changed while cycling through the menu, it will be saved and continue to cycle.
l
While in test mode, it will remain in the selected mode until the menu button is pressed again to exit.
Primex Wireless
Satellite Installation & User Guide
9
Configure and Install Satellite Transmitter
Setup Receiver Switch
