Setup Multiple Transmitters Within the Same Facility
1. Setup and install each Satellite Transmitter and Receiver Switch.
2. The channel number of the Satellite Transmitter is preset to the channel number specified on the red label located on the top of
the box the transmitter was packaged in. Contact Primex Wireless Technical Support if you require assistance.
3. Use the buttons on the Receiver Switch to toggle through to LED menu, and set the channel number to match the XR system
channel with the strongest available signal. This signal may be from either the Primary Transmitter or the nearest Satellite
Transmitter.
4. Cycle power on the Receiver Switch after changing the channel.
l
To cycle power the Receiver Switch, remove the switch cover by removing the two phillip head screws, located in the
upper right and lower right of the unit. Use caution when removing the cover to avoid causing the up or down menu
buttons to fall off the circuit board.
l
Press and release the
Reset
button, located in the upper right corner to the left of the antenna mounting, 1 to 2 times
and verify the green LED begins to flash. The flashing of the green LED indicates a solid signal is being received.
Primex Wireless
Satellite Installation & User Guide
15
