36
Printing from a PC
TOF.
Decrease the Top of form by 0.4mm. This will cause
the printer to start printing before the label and ensure a
fully printed label. Some additional adjustment may be
necessary if the label was not perfectly aligned to begin
with. See Section 4D.
Note:
It is best to over bleed as little as possible to avoid excess ink on the
label backing. Also, over bleeding too much will cause the printer to
skip labels. This is because the printer stops printing too late to sense
the next label.
G. PRINTER DRIVER SETTINGS
Once the printer driver has been successfully installed, you
will need to setup the driver with the appropriate print
options. Refer to the following steps to change or verify your
default printer driver preferences. These settings will apply to
all new designs created in BarTender or other programs after
the preferences were changed. Existing labels saved in
BarTender will not be affected since the preferences are saved
with the label. To change these preferences you will have to
change printer preferences through BarTender. (File Menu -
Printer Settings)
1
2
3
Decrease TOF
Increase Left Margin
Offset
Over Bleed Page Size
Actual Label Stock
Size = 2” x 2”
INDEX
TOC
