Primera DP-XRP, Руководство пользователя

Страница: 57 / 64

Maintenance and Troubleshooting
53
F. CLEARING A MEDIA JAM
If a disc should become jammed inside the printing area of the
Publisher, with the lid closed press the Cartridge Button. This
will eject the Printer Tray. Then open the lid. The Cartridge
Carrier will move to the center position automatically. WAIT
FOR THE CARTRIDGE CARRIER TO STOP MOVING! Then
carefully move the cartridge carrier assembly to the left to gain
access to the printer tray.
The cover must be closed for this operation to complete.
However, in order to access the buttons you must open the
cover. To get around this problem simulate closing the cover by
activating the cover lock sensor. You may do this by putting an
object such as a folded piece of paper in the slot where the lock
would normally be located.
G. TRANSPORTING THE PUBLISHER
To prevent damage to the Publishers robotic arm during
shipment, it is important to properly secure it.
To prepare for transport, remove the ink cartridges and disc
holders, close the front cover and then do the following:
1. With the front cover closed, switch off power to the unit.
2. Press and hold the Cartridge Button.
3. While continuing to hold the Cartridge Button, switch on
power to the unit.
Continue to hold the Cartridge Button for five seconds. After
several more seconds, the robotics will undock and the arm
will lower. Power will shut off automatically once the robotics
are in transport position. If you have the cardboard spacer that
was shipped with the unit, replace the spacer inside the unit
and close the cover. If you don't have the cardboard spacer,
secure the arm and cartridges to the sides of the unit with tape
and close the cover.