13
Connections and Setup
Initial Settings
After you finish connecting your PHD-200 Digital
HDTV Tuner, you need to run initial setup, which
automatically sets up available channels. The initial
setup appears when you turn on your Digital HDTV
Tuner for the first time. If you do not want to set up
the channels at this time, you can do it later by
selecting the CHANNEL of the MENU (see page 19).
1.
Plug the Power Cable into AC In on the back of the
TV
2.
Press
Power
button on the Remote Control or
Front Panel of PHD-200.
3.
Press the
▼
or
▲
button to select language, then
press
OK
button.
4.
Press the
▼
or
▲
button to select Time Zone, then
press OK button.
5.
Press the
▼
or
▲
button to select Daylight Saving,
then press
OK
button.
6.
Press the
▼
or
▲
button to select television signal,
then press
OK
button
)
z
In Cable mode, you can select the correct signal
source among “Cable STD”, “Cable IRC”, and
“Cable HRC” by pressing the
▼
or
▲
button,
then press
OK
button.
z
Contact your local cable company to identify the
type of cable system that exists in your
particular area.
7.
Press the
OK
button to finish the Channel scan.
8.
Change Channel by pushing
CH+
/
CH-
button or
number keys on the Remote Control.
)
z
The channel number is shown up in the top-left
corner of the screen.
z
Check the Antenna and Power Cable
Connection if there is no display.
