Prime Tech POWER MTS175S, Руководство по эксплуатации

Страница: 7 / 22

7
Fig 1
1. Voltage /MMA arcforce/TIG downslope Display meter
a
、
The meter on the front panel can indicate the actual welding voltage or preset MIG voltage.The
indicating number has the precision of 0.1V .The meter indicates the preset during no welding.
b
、
display MMA arcforce
c
、
display tig downslope time
2. Current indicating
The current indicating meter on the front panel indicates the actual welding current during the
welding
，
indicates the preset current during no welding.
3. Power indicating
If the indicating light is on the control circuit connects the power already.
4. indicator tig downslope or post flow time left display)
5. indicator wire speed right display
6. indicator current right display
7. MIG/TIG/STICK Process Selector
Each icon graphically repre-sents each process for rapid eye acquisition when changing processes.
The top function represents MIG. The middle function repre-sents TIG. The bottom function represents
Stick.
8. indicator voltage left display
9. Amp/Wire Speed Adjustment Knob
For Stick and TIG function, this adjusts the amps. For MIG opera-tion,the amps are directly tied to the
wire speed feed. Increasing the speed increases the amps and vice versa. While the unit displays in
m/min for MIG operation, a change in this control also results in a change of amps.
10. Duty Cycle/Overcurrent Warning.
When the duty cycle has been exceeded or an overcurrent, condition has occurred, the L.E.D. will light.
Allow the unit to cool while running until the light goes off or for 10 minutes before resetting the welder. If
condition persists check for loose wires or voltage supply problems.
11. MIG Wave Form Control.
Varies the slope of the current rise time between during short circuit MIG operation. This affects the
actual point where the current has risen sufficiently to burn back the wire.
12. Memory chanel LED
13. CH(chanel)/SAVE Process Selector
led of the"CH(chanel)" lighting when you press or press "3 s" until the led of "SAVE" you have
saved the data.
14. MIG /TIG post flow Process Selector
15. 2T/4T Torch Switch Selector