Prime Tech POWER MTS175S, Руководство по эксплуатации

Страница: 5 / 22

5
Input Connections
Make sure the voltage, phase and frequency of input power is as specified on machine rating plate located
at rear of machine.
Have a qualified electrician provide suitable input power as per national electrical codes. Make sure machine
is earthed / grounded.
Make sure fuse or circuit breaker is correct rating for machine. Using fuses or circuit breakers smaller
than recommended will result in nuisance shut off from welder inrush currents even if welding at low
amperages.
On multiple voltage input welders, be sure the machine is connected as per the instructions for the voltage
being supplied to welder Failure to follow these instructions can cause immediate failure within the welder
and void machines warranty.
WARNING!
ELECTRIC SHOCK CAN KILL
Turn the input power OFF at the mains switch & fuse box before working on this equipment.
Have a qualified electrician install & service this equipment.
Allow machine to sit for 5 minutes minimum to allow the power capacitors to discharge before
working inside this equipment. Do not touch electrically live parts
The POWER MTS175S Inverter Welder requires a 230V 50/60Hz 29amp power supply.
It comes with a 3 metre mains cable attached.
Connect wires according to national coding.
Brown wire - Live
Blue wire - Neutral
Green/Yellow Wire - Earth (Ground)
Connecting to a mains electrical supply
THIS MACHINE IS OF AN INDUSTRIAL SPECIFICATION AND CAN CONNECT
WITH 16A SOCKET.
Connecting to an Engine Driven Generator
I
f connecting this machine to an engine driven generator please ensure
the following Minimum Generator KVA Output - 7.5 KVA
continuous Generator to be fitted with AVR (automatic voltage regulation)
DO NOT USE ON A GENERATOR WITHOUT AVR Connecting to a generator
without the above minimum requirements will invalidate your warranty.