Primax CFE-11C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 39

17
2.2 – Electric wiring
The connection shall be made in compliance with the applicable European regulations. Electric
wiring is single-phased 220 – 230 V ~ 50/60 Hz. .). The condensation hood is supplied with an electric
cable with a plug.
Warning!!! – It is compulsory to fit a two-way safety switch on the hood.
Warning!!! – It is compulsory to ground the installation properly in compliance with the safety
standards of the electric system.
2.3 - Connection to the water system
The connection to the water system must be performed by qualified personnel who shall fit a shut-
off between the water system and the appliance.
Connect the water inlet (1 Fig. 4) of the hood to
the water supply by means of the rubber hose supplied (4 Figure 4). The condensing hood has
been designed to optimize consumption when the network pressure reaches 2 bar. To this end, it is
recommended to fit a pressure gauge and a pressure regulating system upstream of the hood
connection.
2.4 – Drain connection
The water leaving the hood may reach high temperatures of about 80-90 °C. The pipes used to
evacuate water shall be able to withstand such temperatures. The position of the drain is shown in
the picture (3).
2.5 - Mounting and installation of filters
Remove the filter and spacers compensation (where applicable) from the package delivery
accessory and place them in the appropriate positioning guides placed on the sloping front: first
place spacers compensation (where applicable) on the surface of the hood and make sure they
placed on the fins guide, then place the filter on the top rail and then complete the assembly by
tilting the filter until it is correctly inserted at its lower hood.
2.6 –Turning on the appliance
1- water inlet
2- electrical supply
3- water drain
4- connection tube to the water system