TROUBLESHOOTING
CAUTION: Disconnect tool from air supply before performing any service procedure.
PROBLEM
CORRECTION
Air leaking near top of tool ar at
trigger area.
Air leaking near bottom of tool.
Tighten screws.
O-ring or seal worn or damaged – replace damaged
or worn components.
Tool does nothing or operates
sluggishly.
Check air supply.
Inadequate lubrication – Add 5 or 6 drops of oil into
air inlet.
O-rings or seal worn or damaged – replace
damaged or worn components.
Tool jamming frequently.
Incorrect or damaged – Use approved fasteners of
correct gage and size.
Magazine or nose screws loose – Tighten all
screws.
Magazine is dirty – Clean magazine.
Replace worn or damaged driver.
Consult our on-line Technical Support site at support.primatech.ca for updated
documents and more tips.
