PrimAster PMEB 1500, Руководство по эксплуатации

Страница: 29 / 32

GB-6
Troubleshooting
Fault Possible cause Rectification
The motor cannot be No power Check mains supply.
started. Cable damaged Check cable, pull the plug and insert again,
if required, replace the cable or have it
repaired by a qualified electrician
Safety switch/plug combination Have the tool repaired by a specialist
damaged
workshop.
Overheating protection is activated 1. Working depth too deep, continue work with
less working depth
2. Tines are blocked, remove blocking.
3. Soil is too hard, adapt working depth
accordingly and work soil by repeatedly
moving forward and backward over
the same place.
Let the motor cool down for about 15 minutes
before you resume your work.
Unusual Tines are blocked Switch the tool off, wait until the motor fully
sounds stops. Eliminate the cause of the blockage.
Lubricating agent is leaking Have the tool repaired by a specialist
workshop.
Screws, nuts or other fastening Fasten all elements; if the sounds remain
elements are loose contact a specialist workshop.
Unusually strong Tines are damaged or worn out Replace the tines or have them checked by a
vibration specialist workshop.
Working depth too deep. Adjust working depth to a suitable depth.
Bad tilling result Working depth too low. Adjust working depth to a suitable depth.
Worn-out/blunt tines. Replace the tines or have them checked by a
specialist workshop.
Waste disposal and environmental protection
Dispose of the machine properly after it is worn out. Dis-
connect the mains cable in order to prevent misuse. Do
not dispose of the machine with the household waste. In
the interest of environmental protection, take it to a col-
lection point for electric machines. Your responsible local
authority can provide you with addresses and operating
times. Also take the packaging materials and worn out
accessories to the appropriate collection points.
Only for EU countries
Do not discard electric tools in the household
waste!
In accordance with European Directive 2012/19/EC on
waste electrical and electronic equipment and its im-
plementation in national law, waste electric tools must
be collected separately for environmentally-compatible
re-use.
Recycling alternative to the return invitation:
Instead of returning the electric equipment, the owner is
alternatively obligated to take part in the proper recycling
in the case of relinquishment of ownership. The waste
equipment can also be taken to a collection facility which
disposes of it in the sense of the national recycling man-
agement and waste acts. This does not pertain to the ac-
cessory parts and auxiliary equipment without electrical
components accompanying the waste equipment.
Warranty
For this electric tool, the company provides the end user -
independently from the retailer‘s obligations resulting from
the purchasing contract - with the following warranties:
The warranty period is 24 months beginning from the
hand-over of the device which has to be proved by the
original purchasing document. For commercial use and
use for rent, the warranty period is reduced to 12 months.
Wearing parts and defects caused by the use of no fitting
accessories, repair with parts that are not original parts
of the manufacturer, use of force, strokes and breaking
as well as mischievous overloading of the motor are
excluded from this warranty. Warranty replacement does
only include defective parts, not complete devices. War-
ranty repair shall exclusively be carried out by authorized
service partners or by the company‘s customer service. In
the case of any intervention of not authorized personnel,
the warranty will be held void.
All postage or delivery costs as well as any other subse-
quent expenses will be borne by the customer.