36
Victory Viper
I X . T R O U B L E S H O O T I N G
Any electromechanical device requires occasional troubleshooting. However, most problems that arise can
usually be solved with a bit of thought and common sense. Many of these problems occur because the
batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
If you experience any problems with your scooter that you are not able to solve, immediately contact your
authorised Pride provider for information, maintenance, and service.
PROBLEM
POSSIBLE SOLUTIONS
All of my scooter systems appear to be dead.
One of the following actions may eliminate the problem.
n
Remove and reinsert the key back to the on position.
n
Ensure the batteries are fully charged.
n
Push in the main circuit breaker reset button.
n
Ensure that both battery harnesses are firmly connected
to their battery harness mating plugs.
n
Ensure that the front-to-rear cable is firmly connected.
My scooters battery condition meter shows a full
charge, but my scooter does not move when I push the
throttle.
Ensure your scooter was not left in freewheel mode.
(Push down on the manual freewheel lever to restore normal
operation.)
NOTE: When the manual freewheel lever is pulled up, your
scooters brakes are disengaged and all power to the motor/
transaxle assembly is cut.
My scooters main circuit breaker trips repeatedly.
One of the following actions may eliminate the problem.
n
Charge your scooters batteries more frequently.
n
Have both of your scooters batteries load tested by your
authorised Pride provider.
n
Obtain a battery load tester at most any automotive parts
store; follow the directions supplied with the load tester.
My scooters battery condition meter dips way down
and the motor surges or hesitates when I press the
throttle control lever.
One of the following actions may eliminate the problem.
n
Fully charge your scooters batteries.
n
Have your authorised Pride provider load test each
battery.
n
Obtain a battery load tester at most any automotive parts
store; follow the directions supplied with the load tester.