Pride Versa Seat, Руководство пользователя

Страница: 8 / 22

8 Versa Seat with Manual Recline
I V . A D J U S T M E N T
FIGURE 6. Seat Height Adjustment
LOOSEN WIDTH ADJUSTMENT
BRACKET SIDE BOLT
RAISE OR LOWER SEAT
TOWER IN 1-INCH
INCREMENTS
SEAT TOWER (BALL DETENT)
PIN
HEIGHT ADJUSTMENT
There are five different height settings. The holes in the seat towers are one inch apart.
There are four inches of height adjustment; from 18 - 22 inches (measured from the floor to the top of the seat
base).
1. Loosen the width adjustment bracket side bolt on each bracket (four total), using a 1/2-inch wrench. See
figure 6.
2. Remove the seat tower (ball detent) pins (four total).
3. Lift the seat to the desired height.
4. Align the holes.
5. Replace the seat tower (ball detent) pins.
NOTE: Raising the front seat towers higher than the rear seat towers will create a base angle tilt. Each
notch on a seat tower equals five degrees.
6. Retighten the width adjustment bracket side bolts on all four brackets.
TOOLS REQUIRED:
• 1/2-inch wrench
TIE-DOWN
MOUNT