32
www.pridemobility.com
Ultimate
V I I I . D I S A S S E M B LY A N D A S S E M B LY
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 21.
2. Align the lower slots of the front section with the
corresponding pegs on the front of the rear section.
WARNING! Position the front-to-rear
harness so it will not become pinched
between the frame halves when pivoting
the rear section forward. See figure 22.
3. Holding the seat post, slowly pivot the rear section
forward until the curved locking brackets are fully
connected onto the top rear pegs. See figure 22.
4. Raise the tiller.
5. Secure the toggle latch. See figure 19.
!
Lower the toggle latch buckle.
!
Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear harness and both battery
harnesses.
7. Reconnect the battery strap.
8. Replace the shroud.
9. Replace the seat, and lock it into place.
Figure 21. Frame Sections
Figure 22. Frame Lockup
FRONT-TO-REAR HARNESS
PEG
CURVED LOCKING BRACKETS
Содержание Ultimate 3 CF3001
Страница 38: ...38 www pridemobility com Ultimate N O T E S...
Страница 39: ......
Страница 40: ...CastricummerWerf 26 1901 RWCastricum The Netherlands www pridemobility com...