22
Quantum 1121
www.pridemobility.com
V . C O M F O R T A D J U S T M E N T S
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the power base.
3. Remove any wire ties securing the controller cable
to the armrest.
4. Flip up the armrest so it is perpendicular to the floor.
5. Loosen the setscrew on the controller bracket
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Route the controller cable to the back of the power
base and plug in the controller.
11. Secure the controller cable to the armrest with wire
ties. See figure 12.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power
Positioning System, loosen the mounting screws in
the mounting block, transfer the mounting block and
controller to the opposite armrest, and tighten the
mounting screws. See figure 19 .
Foot Platform Height Adjustment
The foot platform height is easily adjusted to one of
several different heights.
To raise or lower the foot platform:
1. Remove the nuts and bolts from the foot platform
bracket. See figure 20.
2. Raise or lower the foot platform to the desired
height.
3. Reinstall the nuts and bolts into the foot platform
bracket and tighten.
Foot Platform Depth Adjustment
T
o adjust the foot platform depth:
1. Remove the nuts and bolts from the foot platform
bracket. See figure 20.
2. Move the foot platform in or out to the desired
depth.
3. Reinstall the nuts and bolts into the foot platform
bracket and tighten.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex
key. See figure 21.
SETSCREWS
MOUNTING
SCREWS
Figure 19. Controller Position Mounting Bracket
FOOT PLATFORM BRACKET
NUTS AND BOLTS
BALL DETENT PIN
Figure 20. Foot Platform Height Adjustment
