32
www.pridemobility.com
Pride Scooter Series
3,3
1. Low battery voltage.
Charge batteries.
2. KSI and throttle turned on at same
Restart the Travel Scooter without
time.
touching the throttle control lever.
3,4
1. Electromagnetic brake driver open.
Contact your authorised Pride Dealer.
2. Electromagnetic brake coil shorted.
3,5
1. Improper sequence of throttle and
Turn key to the off position, then back to the on
KSI, or throttle and inhibit inputs.
position.
2. Misadjusted throttle pot.
4,1
1. Short in motor or in motor wiring.
Contact your authorised Pride Dealer.
2. Controller failure.
4,2
1. Motor voltage does not correspond
Contact your authorised Pride Dealer.
to failsafe throttle request.
2. Short in motor or in motor wiring.
3. Controller failure.
4,3
1. EEPROM failure or fault.
Contact your authorised Pride Dealer.
4,4
1. EEPROM failure or fault.
Contact your authorised Pride Dealer.
2. Short in motor or in motor wiring.
BEEP CODE
POSSIBLE CONDITIONS
SOLUTION
What if the motor runs, but my Travel Scooter does not move?
Your Travel Scooter was probably left in freewheel mode.
When the manual freewheel lever is pushed forward, the brakes are disengaged and all power to the motor/
transaxle is cut.
Pull the manual freewheel lever rearward to restore normal operation to your Travel Scooter.
What if the main circuit breaker trips repeatedly?
Charge the Travel Scooter’s batteries more frequently. See IV. “Batteries and Charging.”
See IV. “Batteries and Charging” or “Appendix I - Specifications” for information about your Travel Scooter’s
battery type.
If the main circuit breaker trips repeatedly, contact your authorised Pride Dealer for service.
What if the battery condition meter dips way down and the motor surges or hesitates when I press the
throttle control lever?
Fully charge your Travel Scooter’s batteries. See IV. “Batteries and Charging.”
Have your authorised Pride Dealer load test each battery.
V I I . B A S I C T R O U B L E S H O O T I N G
