Pride Mobility Revo Sport, Руководство пользователя

Страница: 35 / 38

35
Revo Sport
Your Revo Sport requires a minimal amount of care and maintenance. If you do not feel confident in your ability to
perform the maintenance listed below, you may schedule inspection and maintenance with your authorized Pride
provider. The following areas require periodic inspection and/or care and maintenance.
TIRE CONDITION AND TREAD WEAR
n Regularly inspect your Revo Sport’s tires for signs of wear.
n Use a rubber conditioner on your Revo Sport’s tire side walls to help to preserve them.
WARNING! Do not apply rubber conditioner on tire tread; this may cause the tires to become
dangerously slippery.
EXTERIOR SURFACES
n Bumpers and trim also benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not apply a rubber or vinyl conditioner on a scooter’s vinyl seat; it will become
dangerously slippery.
FLOORBOARD MATS
The Revo Sport’s floorboard mats can be removed should they become damaged or worn to the point of replace-
ment. The floorboard mats are held in place with clips that must be removed from the underside of the scooter’s
floorboards. Replacement mats can be purchased from your authorized Pride provider.
To remove the floorboard mats:
n Position the scooter so the clips are accessible.
n Place a drop of dish soap over the clips. Dish soap acts as a lubricant and aids in the removal of the clips.
n Pull the clips from their positions with a pair of pliers.
WIRING HARNESS
If you remove the battery/charger pack often, it is advised to:
n Regularly check the wiring harness insulation for wear or damage.
n Have your authorized Pride provider repair or replace any damaged connector, connection, or insulation that
you find before using your scooter again.
ABS PLASTIC SHROUD
n The Revo Sport shroud is made from durable ABS plastic and coated with an advanced formula urethane
paint.
n A light application of car wax will help the shroud retain its high gloss.
X I I . C A R E A N D M A I N T E N A N C E
WARNING! Do not apply a rubber conditioner to the floorboard mats; they will become dangerously
slippery.