32
Revo Sport
I X . D I S A S S E M B L Y A N D A S S E M B L Y
ASSEMBLY
NOTE: Raise the tiller before starting to assemble the Revo
Sport.
1. Place the manual freewheel lever in the drive (down) posi-
tion.
2. Raise the tiller and tighten the tiller adjustment knob.
3. Place the battery/charger pack on the frame. See figure 20.
4. Reconnect the wiring harness to the rear of the battery/charger
pack. See figure 21.
5. Secure the battery/charger pack into position.
6. Replace the seat.
7. Rotate the seat until it locks into place.
LIFTING THE REVO SPORT
The Revo Sport is small and lightweight for optimal transport-
ability. To lift the Revo Sport and place it into a transport vehicle,
use the rear bumper and the tiller grip as hand holds. See figure 22.
n
If one person is lifting the Revo Sport (see figure 23) it is
advisable to remove the battery/charger pack.
n
When it is necessary for two people to lift the Revo Sport,
refer to figure 24 for the proper lifting positions.
FIGURE 22. LOWEST TILLER POSITION
TILLER GRIP
FIGURE 24. TWO PERSON LIFT
FIGURE 23. SINGLE PERSON LIFT
(BATTERY/CHARGER PACK
REMOVED)
WARNING! Before lifting the Revo Sport, make certain the tiller adjustment knob is fully tightened.
FIGURE 21. WIRING HARNESS
REMOVAL/RECONNECT
