Jazzy 1170XL
www.pridemobility.com
37
V I . O P E R A T I O N
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests,
you can operate them through the remote keypad. Contact your authorized Pride Provider for information
on how to operate these accessories.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on
the front of the controller. The socket may also be used for reprogramming the controller by using a con-
troller programmer, should this be necessary. If you use an off-board charger, the charger current should not
exceed 12 amps. Contact your authorized Pride Provider for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board
charger/programming socket.
Controller Communications Cable
The controller communications cable provides the joystick module with a connection to the power module
at the back of the power base.
Power Module
Typically, the power module is mounted to the power base. The power module provides a power interface
for the joystick module. It routes the battery power to the motors and other powered accessories such as
lights and power seats.
Actuator Lighting Module (Not Shown)
The actuator lighting module is also located on the power base. The actuator lighting module provides a
control and power interface between the power module, the lights, and/or the power seat actuator.
Sleep Mode
Your Remote Plus controller has a sleep mode feature. Sleep mode is a built-in circuit that automatically
shuts off the main power if the joystick is not moved in any direction for approximately five minutes. The
battery condition meter lights on the keypad indicate sleep mode by blinking once every five seconds. To
restore power and continue, push the on/off key twice.
Thermal Rollback
The Remote Plus is equipped with a thermal rollback circuit. This circuit monitors the temperature of the
motors, power module, and remote. In the event that any of them become excessively hot (above 122° F),
motor voltage is reduced. For every degree above 122° F, the voltage is reduced by 5 volts. This reduces
your power chairs speed and allows the electrical components to cool down. When the temperature returns
to a safe level, your power chair resumes its normal speed.
