Pride Mobility Colt Twin, Руководство пользователя

Страница: 28 / 48

28
www.pridemobility.com Colt Twin
I V . B A T T E R I E S A N D C H A R G I N G
To change the batteries in your scooter:
1. Remove the seat and battery shroud.
2. Disconnect the battery tie-down strap.
3. Disconnect the battery harnesses by pulling them straight up. See figure 11.
4. Disconnect the battery cables from the battery terminals by sliding back the terminal boots and unscrewing the
nut from the bolt.
5. Remove the old batteries from the battery wells.
6. Place a new battery in each battery well. Face the battery terminals of each battery away from the seat post.
See figure 12.
7. Connect the red battery cable to the positive (+) battery terminal on each battery.
8. Connect the black battery cable to the negative (-) battery terminal on each battery.
9. Reposition the terminal boots over the battery terminals.
10. Reconnect the battery harnesses.
11. Reconnect the battery tie-down strap.
12. Reinstall the battery shroud and seat.
Figure 12. Battery Wiring Diagram Figure 11. Battery Removal/Installation
BATTERY TERMINALS UNDER BOOTS
BATTERY
HARNESS
CONNECTIONS
WARNING! Do not mix old and new batteries. Always replace both batteries at the same
time.
WARNING! Contact your authorised Pride Dealer if you have any questions regarding the
batteries in your scooter.
WARNING! Do not replace the batteries while the scooter is occupied.
WARNING! The batteries on your scooter should only be serviced or replaced by an
authorised Pride Dealer or a qualified technician.