Blast/Rev F/Feb03
www.pridemobility.com
39
Drive Program Select Key
The drive program select key enables you to select a drive program and an actuator mode. YourDynamic DX controller was
preprogrammed at the factory for five drive programs 1(slowest) to 5(fastest). The drive mode is indicated by a number in
the center of the keypad.
NOTE: The drive mode settings are preset at the factory. If your authorized Pride provider changes these set-
tings, please make note of these changes.
To change the drive mode program:
1. Press the drive mode select key.
2. Move the joystick right to increase the drive mode program.
3. Move the joystick left to decrease the drive mode program.
4. Press the drive mode select key.
Drive Mode and Actuator Display (also Remote Status Display)
This is a seven segment light that displays the drive program. It also displays a drive inhibit and actuator mode (if applicable),
when they occur.
Actuator Select Keys with Lights
The actuator select keys can control up to five actuators independently. These actuators may control power elevating seats,
power elevating leg rests, power reclining seats, or tilt in space seats. If your controller is programmed with drive inhibit during
actuator operation, the drive inhibit symbol will be displayed during actuator operation. You control the actuators through the
actuator select keys and the joystick. Contact your authorized Pride provider for information on how to operate these actuators.
Remote Status Light
This light will flash if there is an internal Dynamic DX Remote fault, or if an OONAPU fault has occurred. See Out Of Neutral
At Power Up.
Horn Key
The horn key activates the horn.
Battery Saver Feature
When the battery capacity drops to below 21V (typically two lights), the controller will reduce power chair performance to
conserve battery power.
Sleep Mode
The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically shut off the main
power if the joystick is not moved in any direction for a specific amount of time. This time factor is programmed into the
controller. The battery condition meter on the keypad indicates sleep mode by blinking once every five seconds. To restore
power and continue, push the on/off key twice.
Thermal Rollback
The Dynamic DX system features a thermal rollback circuit. This circuit monitors the temperature of the motors, the power
module, and the master remote. In the event these components become excessively hot (above 122° F), the power module
reduces the motor voltage. For every degree above 122° F, the power module reduces the voltage by 5 volts. This reduces your
speed and allows the components to cool down. When the temperature returns to a safe level, your power chair will resume its
normal speed.
V I I I . O P E R A T I O N
