PREVOST X3-45 VIP 2015, Руководство пользователя

Страница: 171 / 190

Appendix B –
Troubleshooting Guide for Multiplex Vehicles
1
Troubleshooting
Problem/Symptom Probable Causes Actions
Vehicle does not Start Rear Start selector switch is
not in the NORMAL position. 1. Check that the rear start selector
switch is flipped up to NORMAL start
position and retry cranking.
2. Flip the rear start selector switch to
“Rear Start” and start the vehicle from
the rear.
CAN network problem
(Multiplex)
Module A53 not powered or
is defective
Engine ECM does not
receive the ignition signal
Engine ECM is not powered
If the vehicle does not start from the rear:
1. Verify that module A53 is powered:
a) Check the Diagnostics menu of the
Driver Information Display (DID).
Select
Fault Diagnostics and
Electrical System. The message
“No Response ModA53, Active”,
indicates a power problem on the
module or a CAN network problem.
b) Check / reset circuit breakers CB1
and CB9.
c) Check / replace fuse F74 and F80.
d) Probe gray connector on module to
see if it is powered.
2. Verify that the engine ECM is powered
and get the ignition signal.
Check / replace fuse F78 and F79.
None of the Multiplexed
functions are operating,
including the basic limp-
home functions (door
opening, flashers, wipers
in speed 1)
Note: The sunshades are
still functioning since
these are not multiplexed
The program version in the
MCM is different than the
program in the I/O modules
and the MCM is forcing all
I/O modules to stay inactive 1. Engage the auto-programming of the
I/O modules: Turn the ignition key to
the OFF position then turn the ignition
key ON. The letters CAN will appear
in the telltale LCD panel for about 3
minutes. Everything shall get back to
normal once the letters CAN are
replaced with outside temperature
display.
2. Try disconnecting the green connector
on the MCM and reconnect.
3. Try disconnecting the MCM
completely, leave it disconnected and
see if the limp-home functions (start of
the vehicle from the engine
compartment, wipers speed 1,
flashers, etc ) are functioning.
Many secondary functions
(not essential for driving) The MCM module does not
receive 24 V power. 1. Check / reset circuit breaker CB2 (2
nd
from the bottom. Check / replace fuse