PREVOST X3-45 VIP 2015, Руководство пользователя

Страница: 108 / 190

Other Features 5-30
Manual retracting procedure – Front and rear
slide-out
1. Turn the ignition switch to the "OFF"
position, and remove the ignition key for
more safety.
2. Deflate the inflatable seal by using the
relieving shut-off valve located on the slide-
out control panel. Turn the handle clockwise
to deflate the seal. Make sure the pressure
indicator reading is "0 psi".
CAUTION
The pressure in the inflatable seal must be
completely relieved to prevent any damage to
the seal.
NOTE
When air pressure is relieved using the shut-
off valve, the normal extending and retracting
operation cycle is disabled, for that reason the
slide-out cannot be moved using the handheld
control.
INFLATABLE SEAL RELIEVING SHUT-OFF VALVE
3. To move the slide-out, use a cordless power
drill with a 3/8" hexagonal bit on the shaft
extension of the slide-out motor.
4. Rotate the slide-out motor shaft extension
with the power drill until the slide-out comes
to its closed position.
5. Once the slide-out room is lined up to its
closed position, remove the tool from the
motor.
NOTE
The front slide-out motor is located inside
the 2
nd
baggage compartment while the rear
slide-out motor is accessible from inside the
vehicle, under the bed structure.
SLIDE-OUT MOTOR ROTATION
CAUTION
Slow down on the closing speed as the slide-
out approaches its closed position. As soon as
the “in limit” stoppers come in contact with
their bearing surface, stop immediately the
power drill rotating movement. Not doing so
could overload the drive mechanism and
cause damage to the reduction gearbox.
6. Finally, the inflatable seal can be re-inflated
by turning the shut-off valve handle
counterclockwise. Check the pressure gage
on the inflatable seal regulator to see if the
pressure is increasing to 10 psi.
0 psi
SEAL DEFLATED
10 psi
SEAL INFLATED
15
10
5
0 psi
20
25
30
15
10
5
0 psi
20
25
30
INFLATABLE SEAL PRESSURE GAGE
NOTE
The slide-out control system inhibits
transmission range selection to prevent the
vehicle from moving if the slide-out is not in its
full "IN" position.