PREVOST X3-45 VIP 2015, Руководство пользователя

Страница: 106 / 190

Other Features 5-28
•
The transmission must be in the "NEUTRAL"
position.
•
Open a window to avoid slide-out movement
restriction.
•
Level the vehicle.
FRONT AND REAR SLIDE-OUT OPERATION
Preliminary condition for the slide-out
operation
Before extending or retracting the slide-out,
please make sure all the following conditions are
met:
1. Make sure the air pressure is 110 psi
minimum on the auxiliary air pressure
gauge.
2. Make sure the parking brake is applied and
that transmission is in the "NEUTRAL"
position.
3. Turn the ignition key to the "ON" position,
start the engine and set the RPM to fast idle.
CAUTION
Before extending or retracting the slide-out,
always open a window to avoid movement
restriction and to prevent the motor from
stopping in overcurrent because of a vacuum
or pressure build up inside the vehicle.
FAST IDLE BUTTON
06264
Slide-out extending operation
With the ignition switch to the "ON" position and
the engine running, press and hold down the
handheld control rocker switch to the "OUT"
position. The green indicator light "ROOM IN
OPERATION" will come on to indicate that the
slide-out operation cycle is activated. The
following actions will be done in sequence:
•
Deflation of the inflatable seal
•
Movement of the slide-out to its full "OUT"
position
Then releasing the rocker switch will permit the
following actions:
•
Re-inflation of the seal
When the rocker switch is released, the green
indicator light goes out. Note that for safety
reasons, releasing the rocker switch will stop the
slide-out movement instantly. At any time,
releasing the rocker switch from the "OUT"
position and pressing it to the "IN" position will
reverse the operation.
CAUTION
The inflatable seals can be re-inflated only
when the slide-out is in its full "OUT" or full
"IN" position. Do not leave the slide-out in any
position other than the full extended or closed
position as water infiltration may occur.
NOTE
Handheld control green indicator light blinking.
A green light blinking indicates an error
condition or missing operation condition on the
slide-out operated by this handheld control.
Refer to SLIDE-OUT TROUBLESHOOTING at
the end of this section if that situation occurs.
SLIDE-OUT HANDHELD CONTROL
26034
Slide-out retracting operation
With the ignition switch to the "ON" position and
the engine running, press and hold down the
rocker switch to the "IN" position to retract the
slide-out. Note that the green indicator light
"ROOM IN OPERATION" will come on. When
the movement of the slide-out to its full "IN"
position is completed, the rocker switch can be
released to allow the re-inflation of the seal. The
green indicator light goes out as the rocker
switch is released. At any time during the slide-
out movement, releasing the rocker switch will
stop the operation instantly.