Page 9
cleaninG The airbruSh:
See our video: How to clean your vFan Airbrush System at:
tinyurl.com/vfan-howtoclean
1. Always clean your airbrush thoroughly.
2. If airbrush is dirty, the spray will be affected or cease.
3. After use, take the product container off from the bottom of the airbrush.
- If using water based paints, place the front of the airbrush (including the
metal tip where product container attaches into) into a bowl of water and
spray thoroughly.
- If using a solvent based or oil based paints, do the same as above. Wear
protective gloves and a respiratory mask.
rePlacinG The TiP:
See our video - vFan Maintenance: Inspecting the tips at:
tinyurl.com/vfan-tip
1. Remove handle, loosen locknut and withdraw needle about one inch.
2. Unscrew the aircap and remove. The tip can now be unscrewed
with wrench .
3. Place a new tip into position and tighten with wrench. The tip must be wrenched
tight. Finally, push the needle forward until it is seated fully forward into tip.
rePlacinG PackinG aSSembly:
1. If packing assembly becomes worn or loose, it must be tightened
or replaced.
2. Tighten packing nut with small screwdriver. To reach packing nut, all internal
parts must be removed.
3. Replace needle and ensure packing nut is not too tight. A slight resistance
to movement is needed when needle is passed through.
4. Completely reassemble airbrush’s internal parts.
2
3
18
11
6
