1
Parts
Auxiliary
handle
Disc
Protective
guard
Spindle
lock
Lock nut
wrench
Inner
flange
Inner
flange
Outer
flange
Angle grinder
cutter head
Outer
flange
Spindle
lock
Auxiliary handle
assembling orifice
Protective
guard
Protective
guard
Switch
Handle
Lock nut
wrench (included)
Abrasive Disc
4
1
/
2
”
included
Disc
Power
cord
Ventilation
slots
6
Assembly
• Disconnect the grinder and set it facing up.
• Set the protective guard in the grinder cutter head as shown. Then set the
pressure washer (
A
) onto the shaft.
• Tighten the four washer screws (
B
) to secure the guard.
• If using wire brushes instead of abrasive discs remove the guard reversing the
previous steps.
Protective guard assembly
• Fix the inner flange in the axis.
• Set the disc in the inner flange.
• Set the outer flange in the axis.
• Press the axis lock in the grinder cutter head.
• Using the lock nut wrench, screw the outer flange until is fixed.
The axis lock can only be used
to replace discs. Never to stop the disc while it rotates.
Disc assembly
• Flanges are not needed to fix this type of accessory. Just
screw the brush (not included) directly into the grinder shaft.
Wire brushes assembly
2
3
4
A
B
ENGLISH
DANGER
5/8-11-UNC-1A
Содержание 24035
Страница 9: ...9 Notas ESPAÑOL ...
Страница 21: ...9 Notes ENGLISH ...