128-7199
10 of 16
10
Resistive Circuits, As Well As 4 Wire Polarity Reversal and 5 Wire Alternating 12 Volt
Door Lock Control Circuits
These applications require the use of additional components which may include relays, fixed resistors, or for
convenience, the AS 9159 Door Lock Interface. Refer to the AUDIOVOX Door Lock Wiring Supplement and or the
Audiovox fax back service for information on your particular vehicle for properly connecting to these types of circuits.
2 Pin Blue Connector :
Push-Button Programming Switch
Route the gray and black wires in the 2 pin connector from the previously installed programming push-button switch
to the control module and plug it into the mating blue connector on the side of the module.
2 Pin White Auxiliary Output Connector :
Low Current Trunk Release Output
This wire pulses to ground via an independent RF channel from the keychain transmitter. This is a transistor-
ized, low current output and should only be used to drive an external relay coil.
WARNING:
Connecting this wire to the high current switched output of trunk release circuits will damage the
control module.
Connect this wire to terminal 86 of the AS - 9256 relay (or equivalent 30A automotive relay) and wire the
remaining relay contacts to perform the selected function of this output.
4 Pin Antenna/Receiver Connector:
(White Connector)
Plug the previously routed three pin connector from the antenna transceiver assemble into the mating connec-
tor of the control module. This connector supplies 12 volts, ground and RF data from the antenna transceiver
to the remote start module. Be certain this connector is firmly seated making good contact to the control unit.
1. RF Programmable Features:
Feature Selection
1 Flash
2 Flash
3 Flash
4 Flash
Default
1 Run Time
5 Min.
10 Min.
15 Min.
20 Min.
10 Min.
2 Ign. 2 During Crank
Off
On
On
3 Light Output During Run
Steady
Flash
Steady
4 Tach Mode
NA
Tach
Tach
5 Voltage Level
NA
NA
NA
6 Trouble Shooting
Off
On
Off
7 Door Locks
1 Sec/1 Sec
3.5 Sec/3.5 Sec
1 Sec/Dbl 1 Sec
1 Sec/1 Sec
8 Crank Time
0.8Sec
1.0 Sec
1.5 Sec
2.0 Sec
1.0
9 Gas/Diesel
Gas
Diesel 10
Diesel 15
Diesel 20 Gas
To program these selectable features:
1. Turn the ignition key to the ON position.
2. Press and release the program push-button switch 3 times.
3. Immediately turn the ignition key OFF, then back to ON.
4. Press and release the program push-button switch 2 times
5. Use Start button on the transmitter to advance to the feature that you want to change.
EXAMPLE
- If you need to
change programmable feature number 3, press and release button 2 on the transmitter 3 times in succession. The
parking lights will flash 3 times confirming that selected feature 3 can now be programmed.
7. Use Lock button on the transmitter to change the selection of the programmable feature. If you are not sure what
the setting for any feature is, press the lock button 1 one time, the parking lights will flash once or twice indicating
the features setting.
NOTE:
Once you enter the feature-programming mode, do not allow more that 15 seconds to pass between steps,
or the programming will be terminated.
NOTE:
If the Glow Plug sense wire, Green/Yellow is connected, this wire will have priority over the setting of feature
#9.
2. Programming Tach Rate:
NOTE:
All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start without
