128-9321
Page 5/8
Page 5
2. If the LED is flashing two times...pause...two times...etc., then an intrusion
attempt was made to the hood, trunk, or an optional sensor that has been
connected to zone 2.
3. If the LED is flashing three times...pause...three times...etc., then an intrusion
attempt was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory and will only
be erased from memory when the ignition key is turned on.
Push-Button LED Valet / SYSTEM OVERRIDE Switch:
The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating
the need to hand your transmitter to parking attendants or garage mechanics.
When the system is in valet mode, all alarm functions are bypassed, however, the
remote panic feature and remote door locks (optional) will remain operational. To
use the valet mode;
1. Enter the vehicle and turn the ignition key to the "on" position.
2. Press and hold the LED valet push-button switch for 5 seconds until the LED
turns on solid. The LED will remain on as long as the system is in the valet mode.
3. To return to normal operation, with the ignition switch on, press and release the
LED valet push-button switch one time. The LED will turn off indicating the unit
has been returned to the normal mode of operation.
In the event you lose your keychain transmitter, or if the transmitter fails to disarm
the system, the valet switch can be used as a system override switch.
Open the car door (the alarm
will
sound). Turn the ignition key on, and press and
hold the LED valet switch on. The alarm will stop sounding, and the vehicle can
now be started.
NOTE:
Always remember to exit Valet Mode to ensure that the vehicle remains
protected at all times.
ELIMINATING THE ARM / DISARM CHIRPS:
The normal arming and disarming confirmation "chirps" can easily be turned on
and off using the valet push-button switch. To do this...
1. Turn the ignition key on, and then off.
