128-9321
Page 7/8
Page 7
PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS
(BANK 1)
Transmitter Model Name, 143BP Is Also Found On Back Of
Transmitter Case (Battery Use CR2032)
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps)
3) Press the Lock Button of each transmitter you want programmed until you hear
a chirp from the horn or siren.
4) Press the valet/program button to advance to the unlock channel two, (siren
chirps)
5) Press the Unlock button of each transmitter you want to operate the unlock
function until you hear a chirp from the horn or siren.
6) Press the valet/program button to advance to the trunk release channel three,
(siren chirps).
7) Press the trunk button of each transmitter you want to operate the trunk release
feature. until you hear a chirp from the horn or siren.
8) Turn the ignition switch off.
The above action programs the Lock, Unlock, & optional Trunk Release,
This remote has the ability to operate 2 similar alarms from a single transmitter.
To toggle on and off vehicle one or two,,,
Press the Trunk/Key the Lock button for 5 seconds.
The LED flashes 2 times. Release the buttons, to select 2nd vehicle mode.Program
this transmitter into the second vehicle's system. Any time you are in 2nd vehicle
when the transmitter is operated, the LED will flash twice for each function. When
in in the prime vehicle mode, the LED will flash once for each function.
Transmitter Battery Replacement:
1) Locate and remove the "00" point Philips head screw on the back of the
transmitter case.
2) Carefully separate the front case from the rear.
3) Slide the CR2032 battery out from under the battery clip and dispose of
properly.
4) Install the new battery with the (+) side facing up away from the circuit board.
5) Close the case and reassemble in reverse of disassembly.
