Prestige 350, Руководство пользователя

Страница: 91 / 116

87/112
EQUIPMENT
GENERAL INTRODUCTION
(As far as possible) use electric appliances with double insulation or with three
conductors (Neutral-Live wire-Ground).
ELECTRONIC
Wire runs are available to complete the boat equipment.
Do not install electronic instruments or repeaters less than 1,50 m away from the radio
loudspeakers.
ADVICE: For further information refer to the appliance instructions.
LEAD LINES
The loch and depth sounder transducers are located in the engine compartment, to port. Keep
the log sensor cowl close to the instrument so as to be able to intervene in complete safety.
Do not store material on top of the sensors.
AUTO PILOT
The pilot consists of several elements listed as follows:
- Repeater, located under the wheel house.
- Compass and Calculator drivers in the cockpit locker.
- To supply power to all elements switch on the "Navigation" circuit breaker on the electrical
panel.
- For use and maintenance of the material consult the manufacturer instructions
MAINTENANCE
Clean the transducer probe during each dry dock and the log sensor regularly. Read the
instructions for maintenance recommendations.
Refer to chapter 12 "Launching" for the precautions to be taken concerning the sensors during
hoisting.
Clean the repeater dials with freshwater. Refer to the instructions before using any other
produce. The use of alcohol must be avoided.
ADVICE - RECOMMENDATION
- For best results, remove any metal compass.
- Do not store material close to the calculator and electrical connections.
ADVICE - RECOMMENDATION
- Place the protective covers on the repeaters when unused for long periods.
- When sailing store the protective covers inside the boat to avoid losing them.
- The various repeater displays are back-lit.
- The onboard radio is fitted with two outside speakers.
- When mooring be careful to adjust the sound so as not to disturb your neighbours.
8
E
L
E
C
T
R
IC
A
L
E
Q
U
IP
M
E
N
T