128-9480
10 of 16
Page 10
Programming Tach Rate:
NOTE: All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to
start the vehicle via the remote start without first programming tach, the unit
will flash the parking lights 7 times indicating tach has not been learned and
stored. If the tach rate is not properly programmed for the specific vehicle, the
unit may not realize that the vehicle is running and in certain instances re-
engage the starter motor.
The Remote Start Unit will learn the tach rate of most vehicle’s single coil, multiple coil
packs, or single injector. To learn tach:
1. Turn the ignition key to the On position.
2. Press and release the valet/program push button switch 3 times.
3. Immediately turn the ignition key Off.
4. Press and hold the valet/program push button switch, then start the vehicle using
the key.
5. When the unit senses the tach signal, the parking lights will begin to flash.
6. Wait for at least 5 flashes.
7. Release the valet/program switch. The parking lights come on for three seconds
to indicate that the learned tachometer signal is stored and the unit is out of the
tachometer learn mode.
NOTE:
If the unit fails to learn tach rate due to an improper tachometer connection or
a poor tach source, the parking lights will not flash. To correct this situation,
locate and connect the Green/Orange Wire to the proper tach signal, and then
repeat the tach learn routine.
PROGRAMMING BANK 1
(TRANSMITTERS):
1. Turn the ignition key to the on position.
2. Press and release the valet/programming switch 3 times (lights flash once).
3. Press the Button of each transmitter you want programmed until the parking lights
flash.
4. Turn the ignition switch off to exit the programming mode.
PROGRAMMING BANK 2
(ALARM FEATURES):
You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of
Bank 1, the lights will flash twice, or you can also go right to bank 2 by:
1. Turn the ignition key to the on position.
2. Press and release the valet/programming switch 3 times (Lights Flash Once).
3. Turn the ignition key off then on, (lights long flash).
4. Press the pushbutton switch once to advance to feature 1, twice to advance to feaure
2, etc,,, then use the button of the transmitter to select the feature setting.
Example to set door lock output timing:
1. Turn the ignition key to the on position.
2. Press and release the valet/programming switch 3 times
3. Turn the ignition key off, then on,
4. Press the pushbutton switch once to advance to features 1, door unlock output timing
then use the button of the transmitter to select your desired setting.
5. To exit the programming mode, turn the ignition key off. The parking lights flash upon
exit
.
