PRESONUS StudioLive RM series, Руководство пользователя

Страница: 45 / 72

41
4 Connecting Your RM-series Mixer to Your Audio System
4.6 Muting All Inputs
StudioLive™ RM-Series Mixers
Owner’s Manual
To monitor on phones:
1. Turn the level control all the way down.
2. Press the Main button to select the main mix for monitoring,
or the Cue button to select the current cue source.
3. Connect a pair of headphones to the jack.
4. Slowly raise the level to the desired listening level.
By default, the cue source is set to monitor the stereo solo bus. For more
information about selecting a cue source,
see Chapter 4.15, “Headphones
and Talkback,” in the StudioLive-AI Software Library Reference Manual .
Power User Tip: The headphone source buttons operate in two modes:
latching and momentary. When the button is pressed and immediately
released, it will latch in the “on” state. When the button is pressed
and held it, will turn on; it will turn off again when released.
4.6
Muting All Inputs
Sometimes it is necessary or desirable to turn all inputs off at once.
Your RM-series mixer makes it easy. To mute all inputs:
1. Press the Mute All button, located on the front panel between the meters and the
phones section. The button will illuminate red, and all inputs will be muted, as is
shown in the UC Surface mixer.
2. Press the Mute All button again to restore all inputs
to their states before they were muted.
Note: The front-panel Mute All button and the Mute All button in
the Global Settings view of UC Surface are linked; changing the
state of the button in either place changes it in the other.
4.7 Metering
RM-series mixers feature a three-color LED grid on the front panel.
Input Meters
StudioLive RM-series mixers offer 32/16 LED input meters that
illuminate to indicate channel input-signal level as follows:
• The LED is green whenever a signal is present on the corresponding input.
• The LED turns red when the channel’s input signal reaches -0.1
dBFS, which usually indicates clipping is about to happen. When
you see this, you’ll usually notice distortion in the sound.
These meters also display the progress during firmware recovery updates,
illuminating in yellow to show progress and green when complete.