3
2
Connections and Controls
2.1
Front Panel
AVB-D 16
Owner’s Manual
2
Connections and Controls
2.1
Front Panel
1. Power LED. Illuminates when the unit is powered on and
blinks when the unit is performing a firmware upgrade.
2. Reset Button. Press and hold for 5 seconds to revert the unit to factory firmware.
3. AVB Sync LED. Illuminates solid when the unit is receiving properly synced
to AVB media clock and blinks if its not properly synced to AVB media clock.
4. AVB Network Activity LED. Flashes as AVB Network activity is detected.
5. Dante Network Activity LED. These LEDs will flash when network
activity is detected on their respective Dante networks.
2.2
Rear Panel
1. Power Inlet. This is the connection for your AVB-D 16 power supply.
2. AVB Network. This locking EtherCON connector can be used
to connect your AVB-D 16 to your AVB network.
3. Dante Network. Use the Primary locking EtherCON connector to connect your
AVB-D 16 to your Primary Dante network. Use the Secondary locking EtherCON
connector for your Secondary or Redundant Dante network. When running a
non-redundant Dante network, only the Primary connection should be used.
3
4
5
1
2
3
1
2
