PRESIDENT RANDY III, Руководство пользователя

Страница: 7 / 68

7
OUTPUT RADIUS
PATTERN
2) BASIC OPERATIONS TO BE CARRIED OUT BEFORE
USING YOUR SET FOR THE FIRST TIME (without trans-
mitting and without using the «push-to-talk» switch)
a)
Check the antenna connections.
b) Turn the set on by turning the Power knob ( 1 ) clockwise.
c)
Set the squelch
OFF
. See §
11
and
12
page 14 .
d) Adjust the volume to a comfortable level.
e) Go to channel 20 by using the channel selectors
s
or
t
key ( 3 ).
3) ADJUSTMENT OF SWR (Standing wave ratio)
WARNING: This must be carried out when you use your CB radio
for the first time (and whenever you re-position your antenna).
The adjustment must be carried out in an obstacle-free area.
* Adjustment with external SWR-meter (e.g. TOS-1 PRESI-
DENT)
a) To connect the SWR meter :
- Connect the SWR meter between the CB radio and the antenna
as close as possible to the CB (use a maximum of 15.75 inches /
40 cm, type President CA-2C).
b) To adjust the SWR meter:
- Set the CB on channel 20.
- Put the switch on the SWR-meter to position
FWD
(calibration).
- Press the «push-to-talk» switch on the microphone to transmit.
- Bring the index needle to
t
by using the calibration key.
- Change the switch to position REF (reading of the SWR level).
The reading on the Meter should be as near as possible to 1. If
this is not the case, re-adjust your antenna to obtain a reading
as close as possible to 1. (An SWR reading between 1 and 1.8 is
acceptable).
English