7
CONGLOMKB .COM
Please contact
or
+61 2 87245218
for further assistance .
Installation (continued)
DRILLING THE HOLES FOR THE UNDERMOUNT
CLIPS
TESTING THE FIT OF THE SINK
- Place the sink (A) underneath the cut-out in the counter to test its
fit. Ensure that the reveal is equal on sides 1 and 3 when viewed
from above . There should also be at least 1 .1 cm of deck revealed
on side 2 to accomodate the slide of the cutting board (F) . Make
adjustments to the cutout if necessary .
-
When you are satisfied with the location of the sink (A), mark the
location of the edge of the counter cut-out on at least two sides of
the lip of the sink .
A
1
2
4
3
1 .1 cm
Counter
Cutting Board
Faucet hole
CAUTION:
Always wear safety goggles and gloves when
using power tools to prevent personal injury .
- On the underside of the counter, mark the location of the
ten holes (5) for the undermount clips (H) . These holes
should be equally spaced around the perimeter of the cut-
out with three on each side 2 and 4 and two on each side
1 and 3 . They should be set back from the cut-out opening
by 4 .1 cm .
- Using an electric drill with a 1 cm drill bit, drill each hole so
that it is 1 cm in diameter and 1 .6 cm deep .
1
4
5
2
3
