11
CONGLOMKB .COM
Please contact
or
+61 2 87245218
for further assistance .
Installation (continued)
INSTALLING THE STRAINER
J
K1
K2
K3
K4
K5
1
2
3
Not supplied
Not supplied
Not supplied
- Apply a small amount of plumber’s putty (not included) in the notch around the
drain hole of the sink .
- Connect the upper strainer body (K2) and the strainer ring (K3), and insert them
into the drain hole from the top of the sink .
- Connect the strainer gasket (K4) and lower strainer body (K5), and insert them
into the drain hole from underneath the sink .
- Insert the strainer screw (K1) through the entire assembly, from the upper
strainer body (K2) to the lower strainer body (K5). Tighten with a flathead
screwdriver .
-
Connect the plastic flange (1) and tail pipe (2), and thread the connecting nut
(3) through the tail pipe and flange up to the lower strainer body (K5). Lock the
connecting nut by hand .
NOTE:
The plastic flange (1), tail pipe (2), and connecting nut (3) are not supplied.
INSTALLING THE FAUCET
1
2
3
4
5
6
7
12
13
14
15
16
18
9
11
8
17
20
19
432mm
(17 in .)
(include a check valve)
(include a check valve)
Working pressure: 0.05 to 0.70 mpa
Working temperature: 0 to 70°C
Product is to be installed in accordance with AS/NZS 3500.1
ONE YEAR LIMITED WARRANTY
Customer service: +61 2 9632 3133 (Monday to Friday, 6:30 am to 3 pm AEDT).
- Unscrew the retaining ring (16) from the bottom of the body base (11), ensuring
that the gasket (14) and washer (15) are removed with the retaining ring .
- Place the lower part of the body base (11) through the hole in the sink .
- From underneath, slide the gasket (14), washer (15), and the retaining ring (16)
until in correct position .
- Tighten the retaining ring (16) by hand, until it is snug .
- Using a wrench or pliers, tighten the entire assembly .
- Gently tighten the two screws (17) on the retaining ring . DO NOT OVER TIGHTEN .
-
Attach the end of the hose with the small fitting (18) onto the faucet outlet (20)
and hand tighten . Then, using one wrench on the hexagonal nut of the faucet
outlet and another on the hose nut, tighten the two ends together . Tightening
with just a single wrench may deform the nut on the hose .
- Install the counterweight (19) on the hose about 432 mm (17 in .) from the
underside of the faucet . This can be adjusted based on your own requirements .
- Screw the sprayer head (1) onto the end of the hose (4) .
- Attach the lever (13) to the handle base (12) .
NOTE:
Please ensure that the flexible risers included in the faucet are not kinked or forced during
installation.
