Page 12
MANIPULACION DISCS
CLEANING DISCS
Before playing, clean the disc with a clean, lint-free cloth. Wipe the disc in the direction of the
arrow.
NOTE:
Do not use so solvents such as benzine, thinners. Commercially available cleaners
or anti static spray damage the unit
Do not insert a disc with the label surface down. Doing so may damage the unit
Do not try to insert another disc when one has been already inserted. Doing so may
damage the unit.
Handle the disc by its edge. And to keep the disc clean, do not touch the surface.
Do not stick paper or tape on the disc.
Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Or
leave it in a car parked in direct sunlight where there can be a considerable rise in
temperature
TROUBLE SHOOTING
To solve the common problem, read the trouble shooting list. If you still can not solve the problem, consult your
nearest service dealer.
Symptom Cause
Solution
The car ignition is not on
If the power supply is properly
connected to the car accessory switch
the ignition key to “ACC”
There is no power.
The fuse is blown
Replace another fuse
The CDs cannot be
loaded
Presence of CD disc inside the
player
Remove the disc in the player then put a
new one upward
Inserting the disc in inside down
Insert the compact disc with the label
facing upward
Compact disc is extremely dirty or
defective
Clean the disc or try to play a new one
Disc cannot be read
Temperature inside the car is too
high
Cool off until the ambient temperature
returns to normal
Volume is in minimum
Adjust volume to a desired level
There is no sound
Wiring is not preoerly connected
Check wiring connection
The operation keys do not
work
Front panel is not properly fix into
Its place
Reinstall the front panel
The installation angle is nore than
30 degrees
Adjust the installation angle to less than
30 degrees
The sound of the CDs
player skips
The disc is extremely dirty or
defective
Clean the compact disc/try to play a
new one
The radio does not work
the radio station
The antenna cable is not
connected the signals are too
weak
Insert the antenna cable firmly
In automatic search mode
the radio does not stop at
a transmitting station.
The transmission signal are too
weak.
Tune in to a radio station manually.
Page 13
SPECIFICATION
GENERAL
Power requirement
DC 12V.
Current consumption
15A MAX.
Power Output
22Watts X 4 (RMS).
Number of channels
2 STEREO channels.
Chasis dimensions
178[W] X 165[D] X50[H] mm.
FM SECTION
Frequency range
87.5MHz -107.9MHz
Usable sensitivity
3uV.
I.F. Frequency
10.7MHz.
AM SECTION
Frequency range
530KHz - 1710KHz
Usable sensitivity
40dB.
I.F. Frequency
450KHz
LINE-OUT (OPTION)
Output
CD MAX. 1200mV
CD PLAYER
System
MP3 audio system
Usable disc
CD, CD-R, CD-RW, MP3 Disc
Frequency characteristics
20Hz-100Hz
5dB
10KHz-20KHz
5dB.
S/N Ratio to CD
50dB [1KHz]
