Page 10
SPEAKER CONNECTION
NOTE:
1. Make sure you use a speaker with 4 ohm load impedance
2. Make sure the auto antenna wire does not come into contact with the vehicle chassis.
-
-
-
-
BLUE AUTO ANT
Page 11
INSTALLATION METHOD
This is an anti-theft installation method.
The main unit wears a METAL MOUNTING SLEEVE.
Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna
according to the requirements of this Instruction Manual, then install the metal
mounting sleeve into the car as per the diagram illustrated below.
METAL SUPPORT S TRAP
To boost up the capability of anti-jamming,
please make sure fix tightly the
support
strap into the metal joint that connect to the
chassis of the car.
metal
Bend the tabs on the metal mounting
sleeve against the DASHBOARD with
a screwdriver.
NOTE
To remove the unit out of the metal mounting sleeve,
insert the two supplied KEYS into the left and right side
slots of the chassis at the same time. Then pull the chassis
out of the metal mounting sleeve as shown in the right
illustration.
METAL MOUNTING SLEEVE
DASHBOARD
FRONT PANEL
PLASTIC TRIM RING
UNIT CHASSIS
To attach the removable faceplate back to the
unit chassis, firstly join the left guide block hole
to the left cylinder, then join the right guide block
hole and the right cylinder, finally flip the front
panel up to combine with chassis.
Remove the two screws that
fix the CD deck mechanism player
dur ing tr ansportation before
mounting the player.
RESET BUTTON
Push this r eset button with a cuspidal
object to renovate the distorted program
once the program is distorted.
Befor e inserting or ejecting disc, press
the OPE N button to flip down the faceplate.
To remove the front panel,
after flip down the front
control panel, push it left
firstly, then draw the right of
the front panel outwards.
INSTALLATION
