premierpet.com
11
Prepare the Receiver Collar
Your receiver collar comes with short contact points installed. Use the long
contact points for pets with long or thick hair. Tighten the contact points
using the test light tool (
5A
) one-half turn beyond finger tight. Check the
tightness weekly.
To Insert and Remove the Receiver Collar Battery
Note: Do not install the battery while the receiver collar is on your pet.
This receiver collar utilizes a replaceable Premier Pet
™
battery (GAC11-16351).
This unique battery is designed to make battery replacement easier and
increase water protection.
To insert the battery, align the symbols on the battery (arrow) and receiver
collar (triangle) (
5B
). Use the edge of the test light tool (
5A
) to turn the
battery clockwise until the arrow lines up with the lock symbol on the
housing.
To remove the battery, turn the battery counter-clockwise using
the edge of the test light tool (
5B
). DO NOT attempt to cut into or pry open
the battery. Be sure to discard the used battery properly. Battery life will
vary depending on how often your pet tests the system and receives a static
correction. Check the receiver collar every month to ensure the battery is
working properly.
If the receiver LED indicator light is flashing every 4 to 5 seconds, battery
replacement is required. Remove the old battery from the receiver collar.
Discharge all power by holding the correction level button down until the LED
is no longer illuminated. Replace with a new battery.
A replacement Premier Pet
™
battery (GAC11-16351) can be found at many
retailers. Contact the Customer Care Center or visit our web site at www.
premierpet.com to locate a retailer near you.
To Set the Static Correction Level
Read all steps before attempting to set the static correction Level.
1. Remove the clear plastic cover with the test light tool to expose the
correction level button (
5C
).
2. With the battery installed, press the correction level button and release
when the receiver indicator light lights up (
5D
).
3. The receiver indicator light will emit a series of flashes representing the
static correction Level.
4. Increase the static correction Level by pressing and releasing the
correction level button within 5 seconds of the previous series of flashes.
5. After setting the static correction Level, replace the cover to protect the
correction level button.
The static correction levels increase in strength from 1 to 5. Pushing the
correction level button while the receiver collar is on level 5 will cause the
receiver collar to revert to Level 1. Refer to the Function and Response Table to
choose the static correction level that best fits your pet.
The receiver collar is equipped to automatically increase the level of static
correction the longer your pet remains in the static correction zone if the collar is set at level 2 or above.
The receiver LED indicator light acts as a low battery indicator, flashing every 4 to 5 seconds when
replacement is required.
Static Correction Level Table
Static Correction
Level
Indicator Light Response
Receiver Collar Function
1
1 Flash
No Static Correction, Tone Only
2
2 Flashes
Low Static Correction
3
3 Flashes
Medium Static Correction
4
4 Flashes
Medium High Static Correction
5
5 Flashes
High Static Correction
Flashes once every 4 to 5 seconds
Indicates Low Battery
5A
5B
5C
5D
