MAG-EXT
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 7
Step 2
Attach the appropriate number of mounting legs to the
projector using the corresponding mounting hardware.
Do not tighten the mounting hardware at this time.
Only attach to the projector manufacturer’s
specified mounting points on the projector chasis
with a minimum three mounting legs. Please follow
all safety instructions specified by the projector
manufacturer as well as the safety instructions
outlined in this manual.
Depending on your application, the long mounting
legs and the short mounting legs may be used
together. There are multiple configurations that may
be used combining the long mounting legs with the
short mounting legs.
Multiple Mounting Point Installation
Step 1
Locate the projector’s mounting points.
®
Position an appropriate number of mounting legs on
the projector.
You can use any combination of three (3) or more
mounting legs, depending on the number and location
of the thread inserts on your projector.
The number and placement of mounting
points on projectors varies between projector
manufacturers. Refer to you projector’s technical
specifications for the number and location of the
mounting points on your specific projector.
Shown with optional security barrel installed.
Step 3
If the mounting legs need to be leveled, rotate the
leveling barrels to level the mounting bracket.
®
To raise the mounting legs, rotate the leveling barrel
clock-wise. To lower the mounting leg, rotate the
leveling barrel counter clock-wise.
Raise or lower each of the mounting legs, by
rotating the leveling barrels, until all of the mounting
legs are at an equal height.
•
Lower the mounting leg by rotating the leveling
barrel counter-clockwise.
•
Raise the mounting legs by rotating the leveling
barrel clockwise.
¯
When the desired position is achieved, tighten the
mounting screws to the projector and then tighten the
hex head leg screws with the M5 Allen wrench.
