MAG-EXT
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 5
Attaching the Projector Plate
Selecting the Mounting Hardware
Insert a small straw or toothpick into the thread inserts
found on the bottom or top of the projector.
®
Use a pencil to mark the depth of the thread insert on
the small straw or toothpick , as shown in Figure 1.
¯
Insert the small straw or toothpick into the remaining
thread inserts to compare and verify their depth.
°
Locate the correct diameter screw for the thread
insert.
If the screw you selected is longer than the mark on
the small straw or toothpick, as shown in Figure 2 and
Figure 3, do not use this screw. The screw length
must not bypass the mark.
±
Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
Does your projector have multiple mounting points
or a single mounting point?
Lock-It™ Security Hardware Pack (Optional)
The MAG-EXT Mount comes with the option of using
Lock-It™ Security Screws. To use the security screws,
simply replace the M6 x 12mm Phillips Pan head screws
with the M6 x 12mm security screws. Once the hardware
has been changed, adjust MAG-EXT Mount and tighten
down the M6 x 12mm security screws using the M5
Security Allen wrench (supplied).
If your projector has multiple mounting points,
proceed to the
“Multiple Mounting Point
Installation”
section.
If your projector has a single mounting point, skip to
the
“Single Mounting Point Installation”
section.
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Attaching the MAG-EXT Mount to the Projector
Locate the mounting points on the bottom of the
projector (see arrows to the left).
Proceed to the
“Attaching the Projector Plate”
section.
