MAG-EXT
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 11
Step 4
Attach the two (2) M4 x 12mm security screws and
star washers that are located on each side of the
locking tab.
Do not release your hold on the projector until the
upper and lower assemblies are engaged and the
locking tab is in place.
The MAG-EXT Mount can be mounted to a ceiling with a minimum 6” thickness. Concrete wedge anchors must
be used for concrete installation. It is recommended that ¼” wedge anchors be used. A masonry bit must be used
to drill the pilot hole. These can be purchased at your local hardware store.
Solid Surface Installation
Begin by placing the upper bridge into position against the ceiling, keeping it level.
®
Mark off four holes to be used for securing the mount and place the upper bridge aside.
¯
Next, drill holes using the appropriate masonry bit for your anchor.
°
Insert a concrete anchor into each hole.
±
If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the ceiling.
²
Once all of the anchors are in place, move the upper bridge back into position.
³
Attach the nut onto the threaded shaft that is protruding from the ceiling.
´
Do not tighten until all nuts are in place.
Proceed to the
“MAG-EXT Mount Adjustment”
section.
MAG-EXT Mount Adjustment
Step 1
After the projector has been installed, the projector must
then be adjusted. To adjust the projector:
Loosen the M5 set screw using the M5 Allen wrench
(both sides).
®
Adjust the projector to the correct position. Firmly
grasp the projector in both hands, and tilt either
forward or backward to adjust the level.
-OR-
¯
Firmly grasp the projector in both hands and rotate
side to side for orientation adjustment.
°
Tighten both M5 set screws using the M5 Allen
wrench.
M4 x 12mm
Security Screw
and Star Washer
Security Wrench
M5 Set Screw
