GB-INWAVP
Page 8
Visit the Premier Mounts website at http://www.mounts.com
Installation
Instructions
Wood Stud Installation (Optional)
Step 1
Use an electronic stud
fi
nder to locate all wall studs in
the area in which you intend to install your
fl
at panel
and your GB-INWAVP.
Use a pencil and lightly mark the location of each
stud.
If your
fl
at panel mounting bracket has suf
fi
ciently large
access openings, consider installing your GB-INWAVP
directly behind the
fl
at panel.
Step 2
Place your GB-INWAVP against the wall with one
edge of your GB-INWAVP aligned with the edge of a
stud.
Level your GB-INWAVP.
Use a pencil and draw an outline on the wall around
your GB-INWAVP.
This is where you will be cutting a hole in the
drywall for your GB-INWAVP. Be absolutely certain
that this is where you want it installed.
Your GB-INWAVP requires a minimum of ¾
″
between the side of your GB-INWAVP and the
nearest wall stud for the In-Wall Clamps to properly
operate.
Use a drywall saw to remove the drywall in the area you
marked in
Step 2
.
Avoid cutting electrical wires, water pipes, or gas
lines! Remove a small piece of drywall and use a
fl
ashlight to look around for these hazards in the
area in which you will be cutting. Once you have
located any hazards, proceed to carefully remove
the rest of the drywall.
If you do locate any hazards, their presence may require
you to relocate either the hazard or your GB-INWAVP.
Consult a quali
fi
ed professional prior to relocating
electrical lines, gas lines, or water pipes.
Step 3
