ECM-3763D
Page 12
Installation Instructions
Technical Specifi cations
All measurements are in inches(mm).
Tilt Positioning
Adjusting the Flat Panel Friction Tilt Angle
1. Place one hand at the center top edge of the
fl
at panel.
2. Place the other hand on the center bottom
edge of the
fl
at panel.
3. Using the upper hand, gently pull the top of
the
fl
at panel toward you while the
lower hand gently pushes the bottom of the
fl
at panel away from you.
Adjusting the Flat Panel to the Original Position
1. Place one hand at the center top edge of the
fl
at
panel.
2. Place the other hand on the center bottom edge of
the
fl
at panel.
3. Using the upper hand, gently push the top of the
fl
at panel away from you while the lower hand
gently pulls the bottom of the
fl
at panel toward
you.
If additional tilt friction is required, tighten the
lower nut and lower bolt only to increase the
tilt friction.
Lower Bolt
Lower Nut
