CTM-MS3-1
Mounting Bracket Installation
NOTE
: Proper installation procedure by qualified personnel as outlined in the installation instructions must
be adhered to. Failure to do so could result in serious personal injury and possible damage to the
flat panel.
WARNING
:
INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO
THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILURE TO DO SO WILL RESULT IN
DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON THE FLOOR WITHOUT ANY
PROTECTION TO THE GLASS. THE FLAT PANEL IS HEAVY AND FRAGILE. AT LEAST (2)
QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS
PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE
TO THE FLAT PANEL.
1.
Once the flat panel is inverted, use a measuring tape to find the center of your flat panel, measuring
from outside to outside of the chassis (Figure 4).
2.
Using a pencil lightly mark the center of your flat panel (Figure 5).
Figure 4
Figure 5
CL
L
C
Top of flat panel
Measuring tape
Inverted flat panel
Inverted flat panel
Mark the center
of the flat panel
Bottom of flat panel
Installation Manual
Page 9
