CTM-MS3-1
2.
Make any lateral shift adjustment and lock it by tightening the two (2) M6 x 30mm Phillips screws
found on the bottom of the mounting brackets. Use the foot leveler to adjust your plasma.
CAUTION
:
Do not over tighten the M6 x 30mm screws to the rods (Figure 16).
NOTE
:
To remove the display from the wall simply back off the M6 x 30mm screws using a Phillips
screwdriver and lift the unit of the wall carefully.
Figure 16
Lateral Shift
Wall Plate
Installation Manual
Page 15