Prem-I-Air EH1896, Руководство пользователя

Страница: 8 / 9

8
PAT TESTING
When used in a workplace, this product should be safety-tested yearly by a qualified
electrician (PAT tested). We recommend that it is PAT tested regularly when used
in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once
every 10 years, or at every change of occupancy. For office and retail premises,
and buildings such as village halls, the wiring must be inspected at least once every
5 years. It is recommended that all buildings be fitted with smoke alarms (it is
mandatory for new buildings).
OPERATING COSTS
At time of going to press, the average cost of electricity is £0.145 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill. At
this cost, the EH1896 will cost £0.29 per hour to run, with the heater on full power
and thermostat set to maximum. If the thermostat is used to regulate the
temperature, the operating costs will be lower, depending on the room temperature
and the size of the room.
MAINTENANCE
Before cleaning, turn the heater off and disconnect from the mains supply. the
heater may then be cleaned using a damp cloth with a drop of washing-up liquid to
remove any dust or dirt from the case. Do not use stronger detergents or solvents
as these may damage the case. Using a dry 1” (25mm) paint brush, remove any
dust from the grilles. If the mains lead is damaged, it must be replaced by the
manufacturer or an authorised service centre. If the mains plug needs to be
replaced, proceed as follows:
Connect the brown (live) wire to the terminal “L”
Connect the blue (neutral) wire to the terminal “N”
Connect the yellow and green (earth) wire to the terminal “E”
Ensure the cord grip is positioned correctly (over the outer sheath of the cable) and
is fully tightened.
13A